Maserati Levante - Park Assist (Optional)

Park Assist (optional)
The Park Assist (also called
“ParkSense”) system provides visual
and audible indications of the distance
between the rear and/or front bumper
and a detected obstacle when backing
up or moving forward, e.g. during a
parking manoeuvre.
Besides the use of the sensors available
on the bumpers and of the rear
parking camera, the vehicle may be
equipped with surround view cameras
(optional) to assist the driver during
manoeuvres on dead-ends/roads and
on intersections. For more details on
this option, see chapter "Surround
View Camera System (optional)" in this
section.
Refer to “Park Assist System Usage
Precautions” for limitations of this
system and recommendations.
Park Assist system will retain the last
system state (enabled or disabled)
from the last ignition cycle when the
ignition is changed to the RUN
position.
Park Assist system can be active only
when the shift lever is in R (Reverse) or
D (Drive).
If Park Assist is enabled at one of these
shift lever positions, the system will
remain active until the vehicle speed is
increased to approximately 12 km/h
(7.5 mph) or above. The system will
become active again if the vehicle
speed is decreased to speeds less than
approximately 10 km/h (6.2 mph).
Park Assist Sensors
The four Park Assist sensors, located in
the rear bumper, monitor the area
behind the vehicle that is within the
sensor's field of view. The sensors can
detect obstacles up to approximately
200 cm (78 in) from the rear bumper in
the horizontal direction, depending on
the location, type and orientation of
the obstacle.
The six Park Assist sensors, located in
the front bumper, monitor the area in
front of the vehicle that is within the
sensor's field of view.
The sensors can detect obstacles up to
a distance of approximately 120 cm (50
in) from the front bumper in the
horizontal direction, depending on the
location, type and orientation of the
obstacle.
Park Assist Warning Messages
Display
The Park Assist Warning screen will
only be displayed if “Sound + Display”
is selected from the MTC+ System.
Refer to “MTC+ Settings” in section
“Dashboard Instruments and Controls”
for further information.
The Park Assist Warning screen is
located on the instrument cluster
display.
It provides visual warnings to indicate
the distance between the rear bumper
and/or front bumper and the detected
obstacle.
The warning display will turn on
indicating the system status (ready or
off) when the vehicle is in R (Reverse)
Before Starting
2
78