To Next PageTo Next Page
Need help?Do you have a question about the Masibus 9000L Series and is the answer not in the manual?
General| Series | 9000L |
|---|---|
| Category | Media Converter |
| Interface | Ethernet to Fiber |
| Fiber Type | Multimode/Singlemode |
| Wavelength | 1310nm |
| Connector Type | SC |
| Storage Temperature | -40°C to 85°C |
| Humidity | 5% to 95% (non-condensing) |
| Mounting | DIN Rail |
Details on input type, range, and impedance for the signal isolator.
Defines output type, range, load resistance, and accuracy specifications.
Information on power supply requirements, consumption, and isolation ratings.
Specifies operating temperature, humidity, protection, and physical dimensions.
Describes terminal type and cable size for connections.
Emphasizes careful reading of instructions and avoiding work with power ON.
Highlights qualified personnel, country-specific regulations, and wiring checks.
Provides block diagrams and connection details for SOP and DOP models.
Instructions for mounting the device onto a 35 mm DIN rail.
Guidance on sequential installation with specified spacing between devices.
Troubleshooting steps for when the device's power indicator LED is off.
Checks for correct output load and signal accuracy relative to input.
Addresses issues like loose connections, wiring norms, noise, and reverse inputs.
