Masport 950913 User Manual

550454 - Masport Petrol Edger Owner’s Manual - July ‘14
www.masport.com
Petrol Edger / Kantensnijder op benzine /
Débroussailleuse à essence / Cortaorillas a gasolina.
IMPORTANT / BELANGRIJK / IMPORTANTE
Part N
o
: 550454
OWNER’S MANUAL.
ENG
Please read these instructions carefully before assembly.
Keep these and the engine instructions in a safe place for
future use.
This manual covers a range of different Masport Petrol Edgers.
Some features mentioned may not apply to your Petrol Edger.
GEBRUIKERSHANDLEIDING.
NLD
Lees deze voorschriften zorgvuldig alvorens de machine te
monteren. Bewaar deze voorschriften en die over de motor
op een veilige plaats om ze later te kunnen raadplegen.
Deze handleiding geldt voor een reeks verschillende Masport-
kantensnijders op benzine. Mogelijk zijn sommige punten niet van
toepassing op uw kantensnijder.
MANUEL D’UTILISATION.
FRA
Lire soigneusement ces instructions avant l’assemblage de
l’appareil. Garder ces instructions et celles du moteur dans
un endroit sûr pour pouvoir vous y référer ultérieurement.
Ce manuel couvre toute une gamme de débroussailleuses
à essence Masport. Les caractéristiques mentionnées ici ne
s’appliquent pas toujours à votre débroussailleuse.
MANUAL DEL PROPIETARIO.
ESP
Lea estas instrucciones detenidamente antes del montaje.
Guarde estas instrucciones y las del motor en un sitio
seguro para uso en el futuro.
Este manual cubre una gama de diferentes Cortaorillas a gasolina
de Masport. Algunas características mencionadas tal vez no
correspondan a su cortaorillas a gasolina.
PANTONE 648C

Masport 950913 Specifications

General

Number of Blades	1
Cutting Height Adjustment	Single Lever
Chassis Material	Steel
Warranty	2 years
Cutting Width	46cm (18")

Summary

Symbols in this Owner's Manual

Symbols used on the Machine

Important Safety Instructions

Preparation

Instructions for preparing the edger before use, including safety checks and fuel handling.

Operation

Guidelines for safe and effective operation of the petrol edger, including controls and usage.

Maintenance and storage

Procedures for maintaining the edger and storing it safely, including part replacement.

Assembling the Edger

Fitting the handle

Step-by-step guide to attaching the handle to the edger body securely.

Preparing the Engine

Instructions for initial engine setup, including oil levels and checking components.

Starting the Engine

Engine Oil Management

Guidance on checking, filling, and changing engine oil for optimal performance and longevity.

Stopping

Operator Presence Control (OPC) Bail

Engine Maintenance

Blade Servicing Instructions

Procedures for inspecting, removing, and replacing edger blades for safety and performance.

Belt Adjustment

Steps to adjust the drive belt tension correctly for proper power transmission.

Troubleshooting