17
may be burning inside. Turn burner off, allow it to cool and try
again.
• Close the gas cylinder valve after each use.
• Never lean heavily on the side shelves of your Pizza Oven or
attempt to transport your Pizza Oven by lifting it from the side
shelves.
• Before you start cooking for the first time, clean the Pizza Oven
thoroughly with hot soapy water. This is necessary to remove
residuals and solvents, oil and grease, which may have remained
from the manufacturing process. The hotplate and grill should be
thoroughly cleaned in the same manner.
• Clean and maintain the appliance after each use.
• “Burning off” the Pizza Oven after every use (for approx 15
minutes) will keep excessive food residue to a minimum.
NOTE:
Before using the Pizza Oven for the first time, the Pizza
Oven must be lit and burning for 30 minutes on the
“low” setting. This will “heat clean” the internal parts and
dissipate odor from the painted finish. The cooking area
may change slightly in colour. It is normal and it is the
nature of the material.
IMPORTANT
The regulator supplied with this Pizza Oven may incorporate an
Excess Flow Control Safety Device. The Excess Flow Control
will activate to prevent gas flow should a regulator malfunction
occur. It is important that the Pizza Oven operator understands
that all gas valves on the Pizza Oven are closed in the OFF
position prior to opening the gas cylinder valve. If the Pizza Oven
valves are open prior to opening the cylinder valve, the Excess
Flow Control will be activated and prevent the Pizza Oven from
being lit. To reset, close the Pizza Oven valves and gas cylinder
valve, wait for 1 minute and use correct lighting procedure as
detailed below.
SAFETY PRACTICE TO AVOID INJURY
• Inspect the gas supply hose prior to turning on the gas. If there is
evidence of cuts, wear, or abrasion, it must be replaced prior to
use.
• Only the pressure regulator and hose assembly supplied with the
appliance should be use. Never substitute regulator for those
supplied with the appliance. Contact customer service for proper
replacement.
• Leak check the hose and regulator connections with a soap and
water solution before operating the appliance.
• DO NOT turn the gas at the LP gas cylinder unless the gas hose
is properly connected to the side burner gas pipe system and all
burner are in the “OFF” position.
• Keep a spray bottle of soapy water near the appliance and check
the connection before each use.
When properly cared for, your appliance will provide safe, reliable
service for many years. However, extreme care must be used as the
appliance intense heat that can increase accident potential.
When using this appliance basic safety practices must be followed,
including following:
• Do not repair or replace any part of the grill unless specifically
recommended in this manual. All other service should be referred
to a qualified technician.
• The appliance is for outdoor use only.
• The appliance is not intended to be installed in or on recreational
vehicles and /ore boats.
• Children should not be left alone or unattended in an area where
the appliance is being used.
• DO NOT allow children to sit, stand or play on or around the
appliance at any time.
• Do not store items of interest to children around or below the grill
or cart. Do not allow children to crawl inside the cart.
• Never let clothing, pot holders or other flammable materials come
in contact with or too close to any grate, burner or hot surface
until it has cooled, the fabric could ignite causing serious personal
injury.
• For personal safety, wear proper apparel. Loose fitting garments
or sleeves should never been worn while using this appliance.
Some synthetic fabrics are highly flammable and should be not
worn while cooking.
• Only certain types of glass, ceramic earthenware, or other glazed
utensils are suitable for grill use.
• Other types of material may shatter with sudden temperature
changes. Use only low or medium heat settings in accordance
with the manufacturer’s guidelines.
• Do not heat unopened food containers as a built-up of pressure
may cause the containers to burst.
• Use a covered band when opening the grid lid.
When lighting a burner, always pay close attention to what you are
doing. Make certain you are aware of which burner you are lighting
so that your body and clothing remain clear of open flames.
WARNING!
• DO NOT touch the grill, pizza stone or immediate surroundings
as these areas become extremely hot and could cause burns.
Use only dry potholders. Moist or damp potholders on hot
surfaces may cause steam burns.
• DO NOT use towel or bulky cloth in place of potholders.
• Grease is flammable, let hot grease cool before attempting to
handle it. DO NOT allow grease deposit to collect in the grease
tray. CLEAN THE GREASE TRAY OFTEN.
• DO NOT use aluminum foil to line the grills rack or grill bottom.
For proper lighting and performance of the burner, keep the burner
spot clean. It is necessary to clean it periodically for optimum
performance. The burner will only operate in one position and must
be mounted correctly for safe operation.
Exercise caution when cleaning the grill. To avoid steam burns,
DO NOT use a wet sponge or cloth to clean the grill while it is hot.
Some cleaners produce noxious fumes or can ignite if applied to a
hot surface.
NEVER USE A DENTED OR RUSTY PROPANE GAS CYLINDER.
DO NOT use the grill to cook excessively fatty meats or other
products which promote flare-ups.
DO NOT operate the grill under unprotected combustible
constructions. USE only well ventilated areas. Do not use in
buildings, garages, sheds or other such enclosed areas.
This grill is designed for optimum performance without the use of
briquettes.
Never use the grill in extremely windy conditions. If located in a
consistently windy area, a windbreak will be required.
LIGHTING THE PIZZA OVEN
Lighting the Pizza Oven is easy, but must be done with due care.
Make sure that the gas is turned on at the cylinder, or that gas is
available to the Pizza Oven. Also ensure that the Pizza Oven door is
open.
BURNER LIGHTING INSTRUCTIONS
1. Open the oven door before igniting the pizza oven.
2. Check the control knob is in the “OFF” position.
3. Open the gas control valve at the gas cylinder.
4. From the “OFF” position, push in and then turn control knob
anticlockwise to the “HIGH” position, hold for 4 seconds.
To Next Page
Loading...