Introduction
01A01-10
HD Series 2600
01
Correct locking of nuts and bolts
With a cotter pin or some other means, check what
condition it is in. It is usually best to replace them
after disassembly.
How to prevent nuts or bolts from shaking
loose under normal working conditions
There are also a number of ways. Experience and
common sense will tell you the best procedure for
each situation.
1 - Lock sealant
2 - Lock washer
3 - Counter-nut
4 - Locking plates
Whenever you use force on a wrench, always
pull it towards you.
If you push on the wrench and it slips, you are likely
to hurt your hands.
Use open wrenches the right way.
Working with the wrench reversed puts more stress
on it.
Don’t improvise.
Fig. 11
Fig. 9
Fig. 10
1
2
3
4
7
7
4
Fig. 12A
To Next Page
Loading...
