Technical Specifications
01B01-8
HD Series 2600
01
11 - Independent hydraulic control valve
2650 2660 2670 2680
Type .................................................................. Independent and closed center
Control valve ..................................................... Double or triple section, mounted on the rear of tractor, permits to operate Singleacting
and Double-acting type cylinders.
Max. flow rate, no combined flow - liters/min (gpm)
37,9 (8,3) 37,9 (8,3) 37,9 (8,3) 37,9 (8,3)
Max. flow rate, with combined flow activated... 55,5 liters/min (12,2 gpm) for tractors with PTO of 540 rev/min and 67,8 liters/min (14,9
gpm) for tractors with PTO of 540 and 1000 rev/min The combined flow, when active,
transfers the hydraulic lift pump flow (17 or 27 l/min)(3,7 or 5,9 gpm) to the auxiliary
Control valve, increasing flow rate. When activating the combined flow, the lift system
Is inoperative.
Relief valve
Maximum pressure - bar (PSI) ......................... 170 (2466) 170 (2466) 170 (2466) 170 (2466)
Maximum flow - liters/min (gpm) ...................... 30 (6,6) 30 (6,6) 30 (6,6) 30 (6,6)
Types and number of valves available: 2 valves
Type 1 ....................................................................................................... 2 valves with spring return type.
Type 2 ....................................................................................................... 2 valves with “kick-out”.
Type 3 ....................................................................................................... 1 valve with spring return and 1 valve with “kick-out”.
Types and number of valves available: 3 valves
Type 1 ....................................................................................................... 3 valves with “kick-out”.
Type 2 ....................................................................................................... 2 valves with “kick-out” + 1 spring return type.
Type 3 ....................................................................................................... 2 valves with “kick-out” + 1 with motor kit.
12 - Independent power take-off
Type:
Dependent - PTO .............................................. Standard Standard No No
Independent - IPTO (Engaged by a hydraulic multidisc clutch)
Optional Optional Standard Standard
Control ...................................................................................................... By a lever on the left of the seat.
PTO Speed ............................................................................................... 540 rpm and 1000 rpm.
Shaft Diameter .......................................................................................... 35 mm (1 3/8 in).
Qty. of splines ........................................................................................... 6 (for 540 rpm shaft) and 21 (for 1000 rpm shaft).
13 - Tractor weight
Shipping weight - Cab version - kg (pounds) .. 2980 (6570) 2980 (6570) 3620 (7980) 3620 (7980)
With balasting - Cab version - kg (pounds) ..... 4001 (8821) 4001 (8821) 6245 (13768) 6245 (13768)
Shipping weight - Footstep version - kg (pounds
) 2227 (4910) 2227 (4910) 2420 (5335) 2420 (5335)
With balasting - Footstep version - kg (pounds) .
2920 (6437) 2920 (6437) 2963 (6532) 2963 (6532)
To Next Page
Loading...
