Standard Cab Installation Instructions:
1. Disconnect rear flasher light harness and remove two-post ROPS from machine. Save
fasteners to re-use later.
2. Remove the seat and seat tracks from the tractor.
3. Take the provided under-seat upholstery and position it in the area under the seat. Glue
down the outer edges of the upholstery onto the tractor sheet-metal.
4. Take the left front bracket and position it on the two holes in the loader sub-frame. Bolt into
place with the provided ½” x 1 ½” bolts and flange nuts. The gusset support on the bracket will
be at the front of the bracket when installed (arrow location).
June 2021© Massey GC1705 ROPS Cab Installation Manual
To Next Page
Loading...
Need help?
General
