5. Take the right front bracket and position it on the two holes in the loader sub-frame. Bolt
into place with the provided ½” x 1 ½” bolts and flange nuts. The gusset support on the bracket
will be at the front of the bracket when installed (arrow location).
** If tractor is equipped without front end loader, use the provided no loader bracket and M12
x 35 flange bolts. Position left front bracket against tractor bell housing where 7 fastener
pattern is, around mid-mower mount. Loosely fasten into place with provided M12 hardware.
Repeat for the RIGHT side.
June 2021© Massey GC1705 ROPS Cab Installation Manual
To Next Page
Loading...
Need help?
General
