EasyManua.ls Logo

Massimo MSU 300 - Page 26

Massimo MSU 300
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
3. Oil routine
①Oil quantity in gasoline is
too few
②Gasoline filter has been
blocked
③Carburetor has been
blocked
Add gasoline
Eliminate
Remove
Engine is too
hot
1.Heat radiation
condition is bad
①Radiating sheet of cooler
has oil stain and sand
②Cooler or water pipe leaks
water
③Corrode, kettle and cooling
liquid could not cycle
normally
④Cooling fan accumulates
too much oil stain or fan
has been damaged
⑤Soft pipe is concaved, and
cooling water could not
flow normally
⑥Water pump happens
malfunction, and cooling
liquid cycle quantity is
short
⑦Temperature saver could
not open normally, and
cooling liquid is blocked
⑧After stopping at high
speed, accumulated heat in
engine is too much and
cooling liquid is boiling
Remove
Check, repair and supply
cooling liquid
Use soft water cooling
liquid or Change
Wash or Change
Adjust by direction
Check or repair
Check 、Change
Avoid
stopping suddenly after
running at high speed
2.Operation method
and transmission
system problem
①Stop suddenly after running
at high speed
②Belt or clutch slips
Change operation method
Check, remove or change