Need help?Do you have a question about the Massive Nano Edge E2 and is the answer not in the manual?
Connect speakers/subwoofers to terminals, checking wiring for proper polarity.
Connect terminal through a fuse or circuit breaker to the positive battery terminal.
Amp detects DC offset for auto turn-on/off or uses remote signal for power.
Connect cable directly to the vehicle frame, ensuring bare metal contact.
Connects to source unit RCA low-level outputs or speaker high-level outputs.
Connects remote controller for subwoofer amplifier volume adjustment.
Matches amplifier sensitivity to source unit signal voltage. Not a volume control.
Selects desired low-pass crossover frequency from 60Hz to 220Hz.
Filters out unwanted low frequencies from 0Hz to 60Hz to improve woofer handling.
Adjusts bass boost level from 0 to 12dB for the bass boost center frequency.
Controls the boosted center frequency, adjustable from 30Hz to 120Hz.
Switch adjusts operating frequency range by selecting LPF or HPF filters.
Controls frequency range for full-range operation (10Hz-300Hz or 100Hz-3KHz).
Connects optional external capacitor for voltage stabilization and improved fidelity.
Selects signal source for amplifier input channels on EX5 model.
LED indicator that lights up when the amplifier is working properly.
Red LED indicates a fault; disconnect and resolve before reconnecting amplifier.
Isolates unwanted ground noise, useful for specific electrical system setups.
To Next Page
General
