Need help?Do you have a question about the Master Audio Design DP 3200 and is the answer not in the manual?
Modular design, rigid chassis, easy access to circuits, and independent safety circuits for protection.
Details on On-Off switch, volume controls, signal indicators, and mode indicators on the front panel.
Describes ventilation, power supply, loudspeaker outputs, LEDs, and mode selection switches on the rear.
Ensure correct voltage and safe connection procedures to avoid damage and noise.
Guidelines for connecting loudspeakers using Speakon or Terminal connectors, including cable cross-section.
How to set up the amplifier for stereo operation using specific mode selectors and output terminals.
Instructions for mono operation by bridging channels, including important impedance considerations.
Setup for parallel mode, enabling bi-amplified configurations without external cables.
Details on connecting pre-amplifiers via balanced XLR-3 inputs for noise rejection.
How to connect optional processing cards for frequency control and speaker optimization.
Information on the electronically controlled fan, importance of unobstructed ventilation, and air filter cleaning.
Step-by-step guide for powering on the amplifier and setting initial gain levels.
Explanation of the clip limiter LED, its function to prevent distortion, and conditions causing protection activation.
Detailed specifications including output power, frequency response, impedance, sensitivity, and dimensions.
Details on the conditions and territories covered by the product warranty.
General| Channels | 2 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Input Sensitivity | 1.4V |
| Input Impedance | 20k Ohms |
| Dimensions | 483 x 88 x 490 mm |
To Next Page
