To Next PageTo Next Page
Need help?Do you have a question about the Master Bilt CCR-49DF and is the answer not in the manual?
General| Category | Refrigerator |
|---|---|
| Model | CCR-49DF |
| Type | Commercial Refrigerator |
| Capacity | 49 cu. ft. |
| Number of Doors | 2 |
| Defrost Type | Automatic |
| Shelves | 6 |
| Exterior Material | Stainless Steel |
| Interior Material | Aluminum |
| Power Supply | 115V/60Hz |
| Door Type | Solid |
| Certifications | NSF |
Avoid partitions/objects restricting airflow and ensure sufficient air space at the rear.
Do not place near heat sources; ensure indoor usage only.
Lock front wheels for stability and ensure the unit is level.
Unit must be connected to a dedicated outlet.
Clean interior/exterior with soap/water, condenser fins periodically, and door gaskets.
Ensure proper power cord connection and wait 5 minutes before re-starting.
Adjust the thermostat (Cool/Cold) for desired temperature; factory setting is 'Normal'.
Interior light activates with door opening; fans activate when door is fully closed.
Plug in, turn on power; default setting is '5', adjustable from 1-9.
Details compressor cycling, defrost control, interior light, and fan operation.
Covers temperature setting, control buttons, and the inner temperature display.
Explains indicators for Quick Cooling, Fan Running, and Door Opening.
Details the Quick Cooling button and its indicator.
Initiate rapid cooling; compressor runs until -10°C or 120 min max; temp buttons inactive.
Use Up/Down buttons to set temperature from 1 (higher) to 9 (lower); auto-locks after 5 seconds.
Displays temperature 14°F-69°F; shows 'LO' below 14°F and 'HI' above 69°F.
Fan indicator for running; door indicator for opening with warning beeps.
Covers powering on, default setting '5', electronic control, and defrost cycle.
Details interior light, fan operation, and critical airflow requirements for freezers.
Covers temperature setting, control buttons, and the inner temperature display.
Explains indicators for D.F., Fan, Door, Manual Defrost, and Door Opening.
Details the manual defrost button and its indicator.
Start defrost by holding the button for 5 seconds; temp controls inactive during manual defrost.
Use Up/Down buttons to set temperature from 1 to 9.
Factory set every 6 hours; coil heats until 60°F; panel displays 'd F' during cycle.
Start defrost by holding the button for 5 seconds; temp controls inactive during manual defrost.
Set temperature 1-9; lock function prevents unauthorized changes; auto-locks after 5 seconds.
Factory set every 6 hours; coil heats until 60°F; panel displays 'd F' during cycle.
Displays temperature -50°F to +50°F; shows 'LO' below -50°F and 'HI' above +50°F.
Fan indicator for running; door indicator for opening with warning beeps.
Remove bottom/top grills, caps; disconnect heater wire from main harness.
Unscrew bolts at top hinge (3 points) and bottom hinge (3 points).
Remove the door assembly; caution regarding heater wire damage.
Swap fixtures, fix hinges, setup door, pull wire, connect wire, assemble caps/grills.
Covers melting food, no/poor refrigeration, loud noise, dew drops, and door closing problems.
Clarifies that refrigerant flow and defrost sounds are not malfunctions.
Covers defects in material/workmanship for one year, including labor for authorized service.
Provides an additional four years of warranty specifically for compressor replacement against defects.
Details pricing policies, approximate delivery, carrier selection, and F.O.B. factory.
Procedure for transit damage claims and note that taxes are not included in prices.
Compensation for cancellations and policy for authorized product returns with handling charges.
Summarizes included one year parts/labor and four year compressor warranty for US/Canada sales.
