What to do if my Master Bilt Merchandiser's evaporator is dirty or iced up?
If the evaporator coil(s) are iced or plugged, defrost or clean them. You may also want to check the control settings.
What to do if the condenser fans are not running on my Master Bilt IM-23GB?
If the fans are not running, you will need to repair or replace them.
What to do if the evaporator fans are not running on my Master Bilt IM-23GB Merchandiser?
If the fans are not running, repair or replace them.
Why is my Master Bilt IM-23GB Merchandiser box not well sealed?
If wall panels are not locked or wall penetrations are not sealed, seal the leaks, adjust the doors, or replace components as needed.
What to do if there is air in my Master Bilt IM-23GB system?
If there are non-condensables in the system, evacuate and recharge it.
What to do if the product load is greater than system capacity on Master Bilt IM-23GB Merchandiser?
If the product load is greater than the system capacity, add additional units or replace the existing one.
What to do if the location of condensing unit is too warm for Master Bilt IM-23GB?
If the location is too warm, or there are air leaks or issues with the doors, ventilate the area or change to a cooler location.
General| Brand | Master Bilt |
|---|---|
| Model | IM-23GB |
| Category | Merchandiser |
| Language | English |
Explains the safety-alert symbol and general safety precautions for using the ice merchandiser.
Emphasizes the need for employers to ensure staff are familiar with all safety information and procedures.
Improper electrical hook-up can result in severe injury or death. All wiring must follow standards.
Installation and service of refrigeration and electrical components must be by qualified personnel.
Addresses slip/fall hazards from moisture and the need for immediate investigation of leaks or malfunctions.
General description of the TLY-25/29 digital controller for cooling, defrosting, and temperature control.
Detailed explanation of each button and LED indicator on the TLY-25 controller for operation and status monitoring.
Step-by-step instructions on how to initiate and end a manual defrost cycle using the controller.
Guide on how to adjust the temperature set point (sp-1) using the controller's UP/DOWN keys and saving changes.
Provides important notes regarding set value storage, factory default settings, and power loss behavior.
A comprehensive list of factory-set parameters for the TLY-25 controller, including symbols, descriptions, and ranges.
Details various alarm messages, their causes, and the corresponding system outputs or behaviors.
Lists other system signals, their messages, and the reasons or conditions they indicate.
Guidelines for connecting cables to the controller, power supply requirements, and relay current limits.
Recommendations for mounting thermostat and defrost termination probes to ensure accurate temperature measurement.
Details common problems like high head pressure, low back pressure, and warm cabinets with their potential causes.
A table listing common problems, their possible causes, and recommended remedies for system operation issues.
A checklist of essential checks for ensuring the proper operation and maintenance of the ice merchandiser.
Routine maintenance for cleaning the condenser coil, emphasizing frequency and methods for optimal performance.
A monthly checklist covering key operational and maintenance checks for the ice merchandiser.
Owner must ensure manuals/labels are included when selling or disposing of the merchandiser.
To Next Page
