TROUBLESHOOTING
If the supply cord is damaged, it must be replaced by a special
cord available from the manufacturer or its service agent.
Never turn the machine upside down or tilt it more than 45 .
Thermostat has been adjusted. No need to adjust it by yourself.
When the machine is below freezing and blocked by ice, the
cooling switch must be turned off for 4 hours before turning
it on again and resuming operation.
Please wait 3 minutes after turning off the power switch
before restarting the machine.
7.
8.
9.
10.
No water
No water running
from taps
Bole supporter
leaking
Noisy operaon
Unstable installaon.
Broken bole.
1. Empty bole.
2. Inlet of bole supporter
blocked by bole seal.
1. Over-consumpon of
water in short me.
2. No power supply
1. wait a moment, then water will be
available again.
2. Connect plug to socket, turn on
switch.
1. Replace it with another one.
2. Clean out wasted paper&bole
seal, install bole again.
Replace it with a new bole.
Place the machine on placid &
solid surface.
Possible CausePROBLEM
Pleasecheckthefollowingbeforehavingthemachinerepaired.
SOLUTION
5
To Next Page
Loading...
Need help?
General
