28
OPERATING INSTRUCTIONS
Checking orifice alignment with burners
Orifices may shift during assembly and movement. Check the orifice alignment with the burners
according to the following illustrations before lighting.
LIGHTING
Warning: Do not lean over grill when lighting.
1. Check that the control knobs are in the OFF position.
2. Open LP cylinder valve.
3. Open lid during lighting.
4. Press and turn the knob slowly to HIGH position. The
burner should light within three attempts.
5. If burner does not light, turn the knob to OFF, wait 5
minutes and then repeat step 4.
6. Once burner is lit, rotate knob to desired heating level
from High to Low.
Orifices stud
inside the air
Side Burner and Orifice Relationship
To Next Page
Loading...
