What to do if the flame goes out during operation of my Master Portable Generator?
If the flame goes out during operation, it could be due to insufficient gas supply. In this case, replace the cylinder. Alternatively, the appliance might be overheating excessively because of insufficient air supply.
Why the flame does not ignite in my Master Portable Generator?
The flame might fail to ignite in your Master Portable Generator due to several reasons: there could be excessive distance between the electrode and burner, in which case you should adjust the distance. Another reason may be lack of gas - replace the cylinder. It could also be due to a faulty gas valve, which requires specialized work. Finally, check if the safety valves have tripped and, if so, press the push-button to reset the safety valve.
What to do if the motor does not turn on in my Master Portable Generator?
If the motor on your Master Portable Generator doesn't turn on, the possible causes are: a faulty mains cable, a faulty fan, or a faulty switch. In each of these cases, you should replace or repair the faulty component.
Why does the flame go out after a few seconds of ignition in my Master Portable Generator?
The flame might be going out after a few seconds due to several reasons. Check the distance between the temperature sensor and the burner; if it's excessive, adjust it. Also, ensure you're holding the gas button pressed long enough, up to 20 seconds maximum. Other potential causes include a faulty safety chain (specialized work needed) or the appliance overheating, in which case you should wait 5 minutes for the safety thermostat to cool down before restarting.
How to fix a yellow luminous outline flame in my Master Portable Generator?
A yellow luminous outline on the flame of your Master Portable Generator indicates an air fault in the burner, so you should clean the air inlet. It may also indicate an excess of gas in the burner; in this case, adjust the pressure and/or replace the nozzle.
To Next Page
General
