What to do if the alarm is chirping, the lamp is on, and the gland nut is glowing blue on my Master MWC-E Laboratory Equipment?
If the alarm is chirping, the lamp is on, and the gland nut is glowing blue, it's likely that the 9000-hour timer has reached its limit because the lamp is a year old. To resolve this, replace the lamp and reset the 9000-hour timer.
Why is the alarm chirping and the gland nut not glowing blue on my Master MWC-E?
If the alarm is chirping and the gland nut isn't glowing blue, it could be due to a burned-out germicidal lamp or a defective power supply. You should replace the lamp and reset the 9000-hour timer, or replace the power supply.
Details on installing the grounding lug for MWC-Series UV systems to ensure a complete ground connection.
Step-by-step guide for correctly installing the quartz sleeve and o-ring into the UV vessel.
Instructions for safely and properly installing the germicidal lamp into the quartz sleeve.
Procedure for initiating the power supply and confirming the germicidal lamp is operational.
Steps for filling the UV vessel with water and purging air before operation.
Protocol for disinfecting the water system using chlorine after UV unit installation.
Essential checks to perform after installation and disinfection to ensure proper function.
Procedure for yearly maintenance including lamp replacement and quartz sleeve cleaning.
Instructions for resetting the 9000-hour timer after lamp replacement.
General| Brand | Master |
|---|---|
| Model | MWC-E Series |
| Category | Laboratory Equipment |
| Language | English |
To Next Page