Mastercare MB-80 - Page 16

Integrity Bath MB-80 Operating Instructions
______________________________________________________________________________________________
MB-80 Operations 2/18/13 800.798.5867
15
BathAire Variable Speed System Control – Basic Operation
BathAire On/Off Button
BathAire Wave Mode
BathAire Purge Cycle
BathAire Internal Timer
BathAire Air Volume (Water Agitation) Adjustment
T
he BathAire can be turned on or off by pressing the blower motor on/off key. Press the button
once and the blower will turn on. Press the button once again and the blower will shut off.
Once the BathAire is on, it is in an adjustable mode. The starts on 60% full speed. To Increase
or decrease the air volume press the more or less air/heat button and hold down until the desired
level is achieved. The heat volume is tied to the air volume and is adjusted the same way.
BathAire
To create the wave effect: Press once for the long cycle, a second time for the short cycle and a third
time to return to normal operation.
The purge cycle comes on automatically 20 minutes after the blower system has been turned off. It
will then run for a period of one minute.
The BathAire system has an internal timer that shuts the blower off automatically after it has run
for twenty minutes.
On/Off
Wave
Wave
More
Air/Heat
More
Air/Heat
Less
Air/Heat
Less
Air/Heat
ThermAire
MasterCare
BathAire
On/Off
On/Off
Wave
MB80OP06 Rev # 0002