19www.mastercool.com
ready the machine for the next process.
20. The machine is now ready for operation. Press the arrows in the middle left of the screen to
return to the start screen.
COMMANDER MACHINE BASIC OPERATION
Once the initial setup of the machine has been completed the machine is ready for operation.
NOTE: The identifying symbol ( ) must appear on the top, middle of the screen before any procedure can begin.
The AUTOMATIC/MANUAL SCREEN will appear on the COMMANDER4100. Choose the reclamation procedure
desired.
• AUTOMATIC: Recover, vacuum, vacuum leak test and refrigerant charge in continuous process
• MANUAL: Recover, vacuum or refrigerant charge can be done individually
NOTE: The top of the screen will display language, pressure, temperature, units’ of measure for refrigerant, time
and date. To change these settings please refer to the main menu instructions at the beginning of this manual.
Once an automatic or manual procedure is selected, the next screen shown allows for the selection of a
standard or hybrid vehicle.
NOTE: Per SAE J2788, automatic oil injection for hybrid vehicles is prohibited. To inject oil into a hybrid
vehicle, use a manual hermetically sealed oil injector. (Follow vehicle manufacture recommendations)
To use the COMMANDER4100 in AUTOMATIC MODE please continue below. If MANUAL MODE is preferred please
skip to the manual section of these instructions.
COMMANDER4100 AUTOMATIC PROCEDURE
AUTOMATIC SCREEN SETTINGS
The automatic screen will display hose flushing, recovery, vacuum, leak test, and refrigerant charge:
To Next Page
Loading...
Need help?
General
