Need help?Do you have a question about the MasterCool COMMANDER Series and is the answer not in the manual?
General| Type | Refrigerant Recovery Machine |
|---|---|
| Model | COMMANDER Series |
| Category | Service Equipment |
| Refrigerant Compatibility | R-12, R-134a, R-22, R-410A, R-404A |
| Frequency | 60 Hz |
| Recovery Rate | 6 lbs/min |
| Compressor | Oil-less |
Inspect machine exterior and interior for visible damage before initial use.
Procedure for filling the internal tank with refrigerant for initial operation.
Key changes users should expect in new recycling machines per SAE J2843.
Guidelines for operating the system safely and understanding potential hazards.
Comprehensive safety instructions covering electrical, fume, heat, and explosion hazards.
References standards and specific cautions for equipment use and protection.
Outlines technician certification needs for refrigerant recovery and recycling compliance.
Guidance on manual content and importance for effective machine operation.
Specifies the product warranty period, terms, conditions, and exclusions.
Machine identification, physical dimensions, weight, and noise level.
Explains the fundamental functions of refrigerant recovery, recycling, and management.
Visual identification and labeling of the machine's main parts and fittings.
How to access and navigate through the main menu options and sub-sections.
Displays current machine data including Tank, Oil, Info, and Vacuum Pump Runtime.
Configuration settings for time, date, language, units, printer, and Wi-Fi connectivity.
Routine upkeep tasks such as tank filling, purging, filter replacement, and system checks.
Procedure for safely disposing of used oil collected in the machine's bottle.
Step-by-step guide to filling the internal refrigerant tank for operation.
Choosing between Automatic and Manual modes for machine operation.
Process to flush residual oil from hoses when switching to hybrid systems.
Machine's automatic procedure for recovering refrigerant from a vehicle.
Automatic vacuum pull and leak testing sequence for the AC system.
Automatic process for charging the vehicle's AC system with refrigerant.
Step-by-step guide for manually flushing hoses, especially for hybrid systems.
Manually initiating and controlling the refrigerant recovery process.
Manually setting and performing the vacuum and leak test procedure.
Manually programming and executing the refrigerant charging process.
Instructions for injecting oil into the AC system during or after operation.
Finalizing the process, clearing hoses, and preparing for the next vehicle.
To Next Page
