DRIVING SCREWS – cont’d
5. While holding the screwdriver firmly
against the screw and the bit aligned
with the screw, press the trigger
switch to start the screwdriver and
drive the screw.
6. When the screw is driven to the
correct depth, release the switch. The
screwdriver will stop.
7. When the switch is released and the
screwdriver stops turning, the spindle
will automatically lock. Fully tighten
the screw by manually rotating the
screwdriver handle in a clockwise
direction.
8. To remove screws, follow the same
general procedure as for driving
screws.
To Next Page
Loading...
Need help?
General
