WARNING: For safety reasons, do not
plug in the charger, charge the battery or
operate the tool until this Owner’s Manual
has been read and understood.
Always use safety goggles or other suitable
eye protection.
Always check to make sure the area where
screws are being driven does not have any
hidden wiring. Contact with a “live” wire will
make exposed metal parts of the tool “live” and
could result in an electric shock to the operator.
Do not drive screws or break into existing walls
or other blind areas where electrical wiring may
exist. If this situation is unavoidable, remove all
fuses or disconnect all breakers feeding the
work area.
Secure the workpiece in a vice or with
clamps. Never hold in hand or across legs.
The rotating action of the screwdriver may
cause the bit to come loose from the screw and
cause injury.
Never carry the cordless screwdriver with
finger on the switch. The tool is always "ON"
when the battery is charged.
Never hold the body of the cordless
screwdriver near the switch while changing
screwdriver bits. Accidentally touching the
switch may start the tool and possibly cause an
injury.
Always use the correct shape and size of
screwdriver bit that matches the head of the
screw.
Do not use worn or damaged screwdriver
bits. Worn or damaged screwdriver bits will not
drive the screw properly and may jump out of
the screw head, causing possible injury.
Always insert the magnetic bit holder fully
into the collet. If not fully inserted, the magnetic
bit holder may jump out of the collet and cause
damage to the workpiece or possible injury.
WARNING: The nickel-cadmium battery is
an integral part of the tool. If it no longer
charges properly or is damaged, the tool and
battery must not be discarded as household
trash, burnt or thrown into water. The tool and
battery must be disposed of as hazardous waste
in accordance with all municipal requirements.
Do not incinerate a discarded battery. It can
explode in a fire.
Do not use an extension cord. Plug the
charger cord directly into an electrical outlet.
Charge the battery only with the charger
supplied with this cordless screwdriver.
Do not use the charger in wet or damp
conditions. It is intended for indoor use only.
Do not use the charger near sinks or bathtubs.
Do not immerse the charger in water.
Do not allow the cord to hang over the edge
of a table or counter or to touch hot
surfaces. The charger should be placed away
from sinks and hot surfaces.
Do not use the charger to charge any
batteries other than the cordless screwdriver
battery. Other batteries may explode.
Do not operate charger if cord or plug is
damaged. Replace damaged cord and plug
immediately.
Do not operate charger if it has received a
sharp impact, been dropped or otherwise
damaged in any way. Have a qualified
technician examine the charger and repair it if
necessary. Do not disassemble the charger.
For best results, charge the battery when the
temperature range of the battery and the work
area is 0–45° C (32–113° F).
To Next Page
Loading...
Need help?
General
