7 8
20V max* LITHIUM-ION CORDLESS DRILL/DRIVER - 054-3118-620V max* LITHIUM-ION CORDLESS DRILL/DRIVER - 054-3118-6
SAFETY GUIDELINES
SAFETY GUIDELINES
Safety guidelines for cordless drill/driver
•
Hold power tools by the insulated gripping surfaces when performing an operation where the tool
may contact hidden wiring or its own cord. Contact with a “live” wire may make exposed metal parts
of the power tool “live” and could give the operator an electric shock.
•
When working with the power tool, always hold it rmly with both hands and provide for a secure
stance. The power tool is guided more securely with both hands.
•
Keep the cord and charger from heat to prevent damage to the housing or internal parts.
•
Secure the workpiece. Clamping devices or a vise will hold the workpiece in place more effectively
than your hand can.
•
Do not allow gasoline, oils, petroleum-based products, etc., to come in contact with plastic parts.
These materials contain chemicals that can damage, weaken, or destroy plastic.
•
Always wait until the machine has come to a complete stop before placing it down. The tool insert
can jam and lead to loss of control over the power tool.
•
Before performing any kind of work on the machine (e.g., maintenance, tool change, etc.) or
when transporting and storing the tool, always set the direction-of-rotation switch to the centre
(locked) position. Unintentional activation of the On/Off switch may result in personal injury.
•
Do not open the battery. There is a risk of a short circuit.
•
Protect the battery from heat and re. There is a risk of explosion.
•
Wear ear protectors when using the drill/driver. Exposure to noise can cause hearing loss.
•
Use protective gloves when removing the bit from the tool, or rst allow the bit to cool down. The
bit may be hot after prolonged use.
•
Use protective gloves when operating the tool. Protective gloves can help to keep you from being
burnt or injured.
•
Keep your hands away from the motor-housing vents. Hot gas comes from the vents during
operation.
•
Release the trigger immediately when a screw is tightened to avoid breaking the screw.
•
For best results, your battery tool should be charged in a location where the temperature is more
than 0°C (32°F) but less that 40°C (104°F). Do not store outside or in vehicles.
Contents
Cordless Drill/Driver, 2 double-ended bits, and Instruction Manual
WARNING!
Remove the Cordless Drill/Driver from the package, and examine it carefully. Do not discard
the carton or any packaging material until all parts have been examined.
WARNING!
If any part of the Cordless Drill/Driver is missing or damaged, do not attach the battery pack
to the tool or use the tool until the part has been repaired or replaced. Failure to heed this
warning could result in serious injury.
To Next Page
Loading...
Need help?
General
