headline bars
continuation tabs
notes
warnings
8
model no. 054-4273-8 | contact us 1-800-689-9928
SAFETY GUIDELINES FOR CORDLESS IMPACT RATCHET
• To reduce the risk of electric shock or damage to the charger and battery, use only the
batteries and charger listed.
BATTERY PACK CHARGER
054-3124-0, 054-3125-8 054-3126-6
• Hold power tool by insulated gripping surfaces, when performing an operation where
the cutting accessory may contact hidden wiring. Cutting accessory contacting a “live”
wire may make exposed metal parts of the power tool “live” and could give the operator an
electric shock.
• Use clamps or another practical way to support and secure the workpiece to a stable
platform. Holding the work by hand or against your body is unstable and may lead to loss of
control.
• Avoid overload working. Do not always use the impact model to raise the torque.
• Do not touch bits, sockets, ratchet component and workpiece immediately after use.
They may be very hot and could burn skin, wear gloves when touching them after use.
• Do not drill, fasten or break into existing walls or other blind areas where electrical
wiring may exist. If this situation is unavoidable, disconnect all fuses or circuit breakers feeding
the worksite.
• Wear safety goggles or eye protection when using this tool.
• Wear ear protectors when using the tool for extended periods. Prolonged exposure to high
intensity noise can cause hearing loss.
• Avoid accidental starting. Be sure that the lock button is on the “off”position before
inserting the battery pack. Carrying appliances with your finger on the switch or inserting
the
battery pack into an appliance with the switch on invites accidents.
• Remove the battery pack before changing accessories. Accidental starting may occur
because battery appliances with a battery inserted are in the operative condition.
• Be prepared for a reaction torque when
“seating”
or removing a fastener. The tool
housing may tend to twist in the opposite direction of the bit rotation when
“seating”
or
removing a fastener, depending on the torque setting of the tool.
• Do not use worn or damaged impact sockets and accessories. When installing an
accessory, insert the impact socket well onto the anvil. Be sure that the anvil has locked onto the
socket correctly.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
SAFETY GUIDELINES
To Next Page