headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
model no. 054-6841-4 | contact us 1-800-689-9928
10
• Be prepared for the reaction torque of the router, particularly if the cutter bit becomes
jammed in the workpiece.
• Become familiar with the working area, and be alert for possible hazards that cannot
be heard due to the noise of the router.
• Never slow the router down with your hands.
• Do not touch the cutter immediately after operation. It may be extremely hot, and could
burn.
• Never stop the router by applying lateral pressure to the cutter.
• Do not force the router. It will do a better job if it is allowed to work at its intended speed.
• Avoid cutting nails and screws. Inspect timber before cutting, and remove all nails and
screws.
• In the event of an electrical or mechanical malfunction, switch the router off immediately,
and disconnect the power cord from the outlet.
• Do not expose to rain or use in damp location.
• The label on your tool may include the following symbols. The symbols and their
definitionsare as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
................. Alternating current
.............. Direct current
n
0
................... No-load speed
............... Class II Construction
…/min ........... Revolutions or reciprocation per minute
............... Grounding terminal
BPM ............... Beats per minute
.............. WARNING – To reduce the risk of injury, user must read instruction manual.
.............. WARNING – To reduce the risk of injury always wear eye protection.
.............. WARNING – To reduce the risk of injury always wear ear protection.
SAFETY GUIDELINES