Frequently blow out or vacuum sawdust or metal chips that accumulate in and on the motor, pulley
housing, table, and work surface.
A coat of furniture-type paste wax applied to the table, column, and machined parts of the base
will help to keep these surfaces clean.
The ball bearings in the spindle and the V-belt pulley assembly are greased and permanently
sealed. Pull the spindle down and oil the spindle sleeve moderately every three months.
CAUTION: Certain cleaning agents and solvents damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents
that contain ammonia. Avoiding use of these and other types of cleaning agents minimizes
the probability of damage.
To avoid shock or fire hazard, if the power cord is worn, cut or damaged in any way, have it replaced
immediately.
WARNING: All repairs, electrical or mechanical, should be attempted only by trained
repairmen. Use only MASTERCRAFT
®
replacement parts; any other may create a hazard.
27
VII. Maintenance
WARNING: To reduce the risk of injury, turn power switch OFF and remove plug from
the power source outlet before maintaining or lubricating your drill press.
To Next Page
Loading...
Need help?
General
