7
II. General safety guidelines (continued)
b. Drum sanders must NEVER be operated on this drill press at a speed greater than the
speed rating of the drum sander.
c. Do not install or use any drill bit that exceeds 7" in length or extends 6" below the chuck
jaws. They can suddenly bend outward or break.
d. Do not use wire wheels, router bits, shaper cutters, circle (fly) cutters, or rotary planers
on this drill press.
e. Use recommended speed for drill accessory and workpiece material.
f. Accessories must be rated for at least the spindle speed setting of the drill press. This drill
press has 5 spindle speeds. Check spindle speed setting of the drill press based on pulley speed
chart located inside the pulley housing. Ensure accessories used have a higher speed rating than
the current spindle speed setting of the drill press. Accessories running over their rated speed can
fly apart and cause injury.
13. DIRECTION OF FEED FOR DRUM SANDING
14. NOTE AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS:
WARNING! For your own safety, read and understand instruction manual before operating
drill press.
• Wear safety glasses or safety goggles.
• Do not wear loose fitting gloves, necktie or loose clothing. Tie back long hair.
• Clamp workpiece or brace against column to prevent rotation.
• Use recommended speed for drill accessory and workpiece material.
• Use only recommended accessories.
• Before, starting, be certain chuck key is removed from chuck and that motor, head and table are
locked.
• Keep pulley cover closed when not making belt adjustments.
• Unplug drill press before making bit/accessory changes, adjustments or repairs.
• Do not expose to rain or use in damp locations.
15. THIS DRILL PRESS HAS 5 SPEEDS: 620 RPM, 1150 RPM, 1630 RPM, 2180 RPM AND
3070 RPM. See inside of guard for specific placement of belt on pulleys.
16. THINK SAFETY
SAFETY IS A COMBINATION OPERATOR COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE DRILL PRESS IS BEING USED.
KEEP THIS USER’S MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE
WARNING! Feed workpiece into a sanding drum or other approved accessory, against the
direction of rotation.
WARNING! A kickback occurs when workpiece suddenly binds on the cutting edge of the tool
and the workpiece is thrown by the cutter in the direction of the cutter’s rotation. This can cause
serious injury.
To Next Page
Loading...
Need help?
General
