OPERATING INSTRUCTIONS
12
AIR-POWERED GRAVITY-FEED SPRAY GUN 058-9312-8
Before assembly and preparation
• After unpacking the tool, inspect it carefully and check thoroughly for any damage that may
have occurred during transit. Ensure the tightness of fittings, bolts, etc., before performing
service operation.
Paint filling
• Mixing and thinning of paint should be performed in accordance with the paint manufacturer’s
instructions. Most materials readily spray if thinning is properly performed.
N
ote: Always thin the paint with care.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Do not exceed the maximum pressure for the Air-powered Gravity-feed Spray
Gun or any other parts in the compressor system. Failure to comply could lead
to serious injury or loss of life.
• Never aim or spray at yourself or anybody else as this could cause serious
injury. Failure to comply could lead to serious injury or loss of life.
CAUTION!
Potential hazard that may result in moderate injury or damage to
e
quipment.
• Do not exceed the thinning recommendations of the paint manufacturer. Failure
to comply may result in moderate injury or damage to equipment.
To Next Page
Loading...