TROUBLESHOOTING
19
AIR-POWERED FULL-SIZE DIE GRINDER 058-9332-0
Note: For further repair information, please call 1-800-689-9928.
Tool is not running.
Air flows freely from
exhaust.
Motor vanes are stuck due to
material build up.
1. Pour pneumatic tool oil into air inlet.
2. Operate the tool in forward and/or reverse
rotation within a short duration.
3. Tap motor housing gently with plastic mallet.
4. Disconnect the tool from the air supply.
Operate the motor manually by rotating drive
shank (wherever applicable).
5. If tool remains jammed, return to service
center
.
Tool does not shut
off.
O-rings or throttle valve is dislodged
from seat valve.
Replace O-rings or return to service center.
PROBLEM POSSIBLE CAUSES SOLUTIONS
To Next Page
Loading...