IMPORTANT INFORMATION
13
AIR-POWERED DUAL-ACTION SANDER 058-9325-8
Read this instruction manual thoroughly or have tool operators read thoroughly before using the tool.
• Read all safety guidelines
(see section “Safety guidelines”)
at the beginning of this manual.
• Always inspect the air tool prior to each use to
– Ensure proper use of power source.
– Determine whether the tool is in proper working order.
• Use sanding pads which are specifically designed for this tool.
(see section “Technical
specifications”)
.
• Drain the compressor tank daily. Water in the air line will damage the tool.
• Clean the air inlet and the filter weekly.
• Line pressure should be increased to compensate for unusually long air hoses (over 8 meters).
The hose diameter should be 3/8" I.D.
CAUTION!
Potential hazard that may result in moderate injury or damage to
e
quipment.
•
Verify that all connections in the air supply system are sealed in order to
prevent air from leaking. Failure to comply may result in moderate injury or
damage to equipment.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Do not use the tool if it is not in proper working order.
• Do not use oxygen or any other combustible or bottled gas to power this tool.
• Do not use this tool in the presence of any flammable liquids or gases.
• Keep hose away from heat, oil, and sharp edges. Check hose for wear and
tear, and ensure that all connections are secure. Failure to comply could lead to
serious injury or loss of life.
To Next Page
Loading...
