MAINTENANCE
18
AIR-POWERED DUAL-ACTION SANDER 058-9325-8
• Air-operated tools must be inspected periodically, and worn or broken parts must be replaced
in order to keep tools operating safely, and efficiently.
• Inspect and replace worn or damaged O-rings, seals, etc. Tighten all screws and caps
frequently in order to help prevent personal injury.
• Inspect the trigger, the spring and the safety mechanism for free movement on a regular basis
in order to ensure that the safety system is fully functional.
• Verify that no part is loose or missing and that no part is stuck or jammed.
• Check the air supply for correct size and type of hose connectors. To avoid loss of power or
erratic action, ensure that there is no additional drain on the air line and no moisture or
restriction in the air pipe.
• Clean the air strainer (if provided in your model) in the air inlet region of the tool and remove
grit or gum deposits which may lead to loss of power or erratic action and may also reduce
the performance of the tool.
Storage
If it is necessary to store the tool for an extended period of time, apply a generous amount of
lubricating oil before storing. The tool should be allowed to run for approximately 30 seconds after
lubricating, in order to ensure that the lubrication is uniformly distributed throughout the tool.
• When the tool is not in use, disconnect it from the air supply, clean, and store it in a safe, dry,
and childproof location.
• When temperatures are below freezing, keep tools as warm as possible using any safe,
convenient method.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• Never use damaged/worn sanding pads. Failure to comply could lead to
serious injury or loss of life.
CAUTION!
Potential hazard that may result in moderate injury or damage to
e
quipment.
• The tool should be stored in a clean and dry environment. Failure to comply
may result in moderate injury or damage to equipment.
To Next Page
Loading...
