TROUBLESHOOTING
20
AIR-POWERED DUAL-ACTION SANDER 058-9325-8
Note: For further repair information, please call 1-800-689-9928.
Tool stops working.
Air flows freely from
exhaust.
One or more motor vanes got stuck
due to material build up.
1. Pour lubricating oil into the air inlet.
2. Tap motor housing gently with plastic mallet.
3. Operate the tool by reversing rotation of the
tool back and forth in short duration. Repeat
the above steps as needed.
4. Disconnect the air supply. Operate the motor
by manually rotating the drive shank.
(wherever applicable)
.
I
f the problem persists, call 1-800-689-9928.
Tool does not shut
off.
Throttle valve O-rings are dislodged
from seat inlet valve.
Replace O-rings.
I
f the problem persists, call 1-800-689-9928.
PROBLEM POSSIBLE CAUSES SOLUTIONS
To Next Page
Loading...
