IMPORTANT INFORMATION
14
AIR-POWERED HAMMER/CHISEL 058-9331-2
• It is recommended that an automatic in-line filter-regulator-lubricator be used and be located
as close to the tool as possible.
• If a filter-regulator-lubricator is not installed, place up to six drops of oil directly into the air
inlet plug before each use.
• If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the
air pressure to the tool, which will cause a reduction in power, efficiency, and general
performance.
AIR TOOLS
R
ead this instruction manual thoroughly or have tool operators read thoroughly before using the tool.
• Read all safety guidelines
(see section “Safety guidelines”)
at the beginning of this manual.
• Always inspect the air tool prior to each use to
– ensure proper use of power source.
– determine whether the tool is in proper working order.
• Drain the compressor tank daily. Water in the air-supply line will damage the tool.
• Clean air inlet and filter weekly.
• Line pressure should be increased to compensate for unusually long air hoses. The hose
diameter should be 3/8" (9.5 mm) ID. The fittings must have the same inside dimensions.
• Ensure that the trigger is not pressed before connecting the tool to the air supply.
CAUTION!
Potential hazard that may result in moderate injury or damage to
e
quipment.
•
Verify that all connections in the air-supply system are sealed in order to
prevent air from leaking. Failure to comply may result in moderate injury or
damage to equipment.