76
model no. 058-9807-2 | contact us 1-800-689-9928
Do not use oxygen or any other combustible or bottled
gas to power air-powered tools. Failure to observe this
warning can cause explosion and serious personal
injury or death. Use only compressed air to power
air-powered tools. Use a minimum of 25' (7.6 m) of
hose to connect the tool to only compressor. Failure to
comply will result in serious injury or death.
Risk of inhalation: Never directly inhale the air produced by the
compressor.
Risk of electric shock: Do not expose a compressor to rain.
Store it indoors. Disconnect the compressor from the power
source before servicing. The compressor must be grounded.
Do not use grounding adaptors.
Risk of personal injury: Do not direct compressed air from the air hose
towards the user or other people or animal.
Risk of burns: The pump and the manifold generate high temperatures. In
order to avoid burns or other injuries, do not touch the pump, the manifold,
or the transfer tube while the compressor is running. Allow the parts to cool
down before handling or servicing. Keep children and pets away from the
compressor at all times.
Risk of bursting: Do not adjust the pressure switch or safety valve for any
reason. They have been preset at the factory for this compressor’s maximum
pressure. Tampering with the pressure switch or the safety valve may cause
personal injury or property damage.
Risk of bursting: Make sure the regulator is adjusted
so that the compressor outlet pressure is set lower
than the maximum operating pressure of the tool.
Before starting the compressor, pull the ring on the
safety valve to make sure the valve moves freely.
Drain water from the tank after each use. Do not weld
nor repair the tank. Relieve all pressure in the hose
before removing or attaching accessories.
SAFETY GUIDELINES
SAFETY GUIDELINES
SAFETY GUIDELINES
Potential hazard that will result in serious injury or loss of life.
Potential hazard that could result in serious injury or loss of life.
• Do not allow unskilled or untrained individuals to operate the
Gravity-feed Spray Gun.
• Use components recommended by manufacturers: Never modify the
tool for other applications. Use only parts, nozzles, and accessories
with specifications as mentioned in this manual (see section “
Technical Specifications”).
• Inspect the tool components and attachments before operation and
ensure that they are assembled properly and are not damaged.
Failure to comply could lead to serious injury or loss of life.
• Locate the compressor in a well-ventilated area for cooling, at a
minimum of 12" (31 cm) away from the nearest wall.
• Protect the air hose and the power cord from damage and puncture.
Inspect them for weak or worn spots every week, and replace them
if necessary.
WARNING!
DANGER!
• Keep children away from the work area. Do not allow children to
handle power tools.
• Do not point the tool towards yourself or other people, even when
the tool has stopped. Keep hands, feet, and all other parts of the
body clear from work area.
• Never use homogenate hydrocarbon solvent, which can chemically
react with aluminum and zinc parts and which is not chemically
compatible with aluminum and zinc parts.
To Next Page
Loading...
