MasterCraft 2013 XStar User Manual

2013 MasterCraft Owners Manual • Preparation • Page 4-7
Therstfty(50)hoursofoperationarethemostimportantfortheboat.Proper
break-inwillensuremaximumperformanceandthelongestpossiblepower-trainlife.
The break-in period allows moving parts within the engine and transmission to wear-in
properly. All MasterCraft boats are lake-tested on the water before leaving the factory,
but the break-in must continue for the first fifty (50) hours of your ownership.
To ensure proper break-in and lubrication,
boat owners should not remove the fac-
tory break-in oil until after the initial ten
(10) hours of operation and before twenty-
five (25) hours. At that time, an oil change
should be performed on the Ilmor engines by an authorized Ilmor/Mas-
terCraft dealer.
Failure to follow the break-in procedure exactly as stated will void the engine
warranty!
NOTE: Before operating the boat for the first time you must read the engine manufac-
turer’s manual completely in addition to this Manual!
 Pleasefollowthebreak-inprocedurecarefully.Closeattentiontothefollowingis
very important:
• Maintain the proper oil level. Untilthepistonrings,cylinderandotherworkinginter-
nal parts are thoroughly seated, oil consumption can be high and must be carefully
watched. (This continues to be important after break-in, as well).

MasterCraft 2013 XStar Specifications

General

Brand	MasterCraft
Model	2013 XStar
Category	Boat
Language	English