MasterCraft 2013 XStar - Page 127

2013 MasterCraft Owners Manual • Preparation • Page 4-11
Underway
If the oil pressure gauge indicates low or no oil pressure, immediately stop the boat as
outlined below and check the oil level. If the temperature gauge indicates overheating, stop
the boat when it is safe to do so as outlined below and check the raw water system for block-
age.DONOToperatetheboatuntilthecauseforthewarninghasbeenfoundandcorrected.
Continued operation after the warning light
has illuminated may cause severe engine
damage. This will void your warranty.
Stopping
Step 1: Slowlybringthecontrollevertotheneutralposition.Iftheboathasbeendriven
foralongperiodoftimeorathighspeed,allowtheenginea2-3minutecool-
downperiodatlowidle(600-800RPM).
Step 2:  TurntheignitionkeytotheOFFposition(ProStar190or197)tostoptheengine
orpresstheENGINESTART-STOPbutton(allothermodels).
Step 3: If any problems were encountered during operation, have the boat inspected by
an authorized MasterCraft dealer. Request any necessary repairs before resum-
ing operation of the boat.
Step 4: At the conclusion of the outing, turn the key o and remove from the key slot.
DoingsowillensurethatyouhaveturnedOFFtheelectricalsystem,andprevent
others from starting or running the boat.