2013 MasterCraft Owners Manual • Care and Maintenance • Page 5-9
AquaTrac platforms:
AquaTrac should be handled only with clean hands. Oil, grease or dirt may leave per-
manent imprints on the surface. Whenever possible, keep the platform covered when the
boat is not in use. It should be stored dry.
Spills: Scoop or scrape up as much of the spill as possible, followed by a thorough
blotting of the remaining spotting with a dry, clean cloth. If cloth is not available, paper
towels are an acceptable substitute.
Non-oil Based Stains: Create a detergent solution by adding 1/4” (one-quarter inch)
teaspoon of liquid dish detergent to one (1) cup of warm water. Apply the solution to the
aected area (do not scrub) and blot with a dry, clean cloth. Repeat the process until
the stain stops transferring to the cloth. If the stain still appears on the platform, apply
the solution to the area and allow it to stand for 2-5 (two-to-five) minutes. Then rinse
with clear, clean water.
Oil-Based Stains: Apply naphtha-based (hydrocarbon petroleum) solvent or mineral
spirits to the aected area and follow the instructions on the solvent container. Use care
when using such solvent cleaners as directed on the container instructions as there may
be health matters to consider when using these solvents. Always work from the outside
into the center of the stain. Do not scrub!
To Next Page
Loading...
Need help?
General
