Models
ProStar, as an option
Purpose
Two removable rear seats allow additional passengers to be trans-
ported in the boat. The seats can be removed when not needed.
Location
Aft section of the cockpit, port and starboard.
Operation
Removal: Lift the forward edge of the seat bottom. Rotate up and
pull forward at the same time. Two hooks on the seat back will re-
lease from eyelets connected to the rear deck wall. When released,
lift seats out of the boat and store.
Installation: Set the seat on the cockpit floor near the aft cockpit
wall. Lift the forward edge of the seat bottom. Slide the seat rear-
ward until the seat back hooks touch the aft cockpit wall just blow
the eyelets. Set the seat bottom down slowly, ensuring that both
seat back hooks pass through an eyelet.
Never operate the boat without the rear seats installed properly.
Seat back hooks firmly captured by the eyelets and all four foot
pads sitting on the cockpit floor.
SURF SLEEVES
Models
Optional on all boats equipped with a bimini.
Purpose
Surf sleeves allow surf boards to be stowed during boat operation
without taking up additional space on deck. This is particularly con-
venient for surf boards which may not fit in storage compartments.
Location
Surf sleeves are mounted on top of Bimini canvas.
Operation
Slide surf boards inside one of the four pockets and snap the pro-
2021MCOwnerManualFINAL.indd 309 8/26/20 1:53 PM
To Next Page
Loading...
Need help?
General
