2021 OWNERS MANUAL / 84
PV1100 TOUCHSCREEN
NAVIGATION AND OVERVIEW
Navigation within the PV1100 touchscreen is controlled via touch
commands. The PV1100 touchscreen is divided into upper and a
lower halves which change depending on the operating mode.
Operating Modes
The MasterCraft Dual Screen dash is organized around three main
on water activities: driving from place to place, towing riders and
chilling. To correspond with these activities, the Dual Screen Dash
features three primary operating modes: Drive, Tow and Chill.
• Drive Mode displays basic operating information for cruising. From
Drive Mode you can quickly adjust the boat’s speed, tabs and ballast.
• The Tow Mode is broken down into Surf, Wake and Ski. Factory
loaded profiles for ballast, speed and tab configurations are easy
to select and change. New custom profiles can be created in each
of the tow modes.
• Chill mode features expanded stereo controls and makes it easy
to find and play your favorite music.
To switch between these modes tap the buttons at the top of the
touch display. Note that operators cannot switch between modes
while the throttle is in gear (forward or reverse).
boat is in (Drive, Chill or Tow), the way information is displayed on
the screen varies. The center of the screen is dedicated to one of
three dierent display settings, camera view, navigation or media.
To navigate between these views: use the five-button keypad
directly below the screen to the right of the steering wheel. Press
the LEFT and RIGHT directional buttons to scroll through the
dierent views.
Pressing UP and DOWN on the five-button
keypad will cycle the screen between wide
screen and standard screen viewpoints.
Pressing the center OK button acknowledges
alerts and engine notifications.
Drive, Tow and Chill modes always display critical boat and engine
information on the screen, with a speedometer always on the left
third of the screen. The information on the right third of the screen
varies based on the mode. Chill mode displays audio information on
the right third, Drive mode displays engine RPM, and all three Tow
Modes display tab and ballast levels on the right third of the screen.
The information in the center of the screen will change depending
on what display setting is currently selected: camera view,
navigation or media.
2021MCOwnerManualFINAL.indd 84 8/26/20 1:51 PM
To Next Page
Loading...
Need help?
General
