EasyManuals Logo

MasterCraft prostar 197, X-7 User Manual

MasterCraft prostar 197, X-7
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
mastercraft 2010 ow n e r s m anual page 20 -2
Steering problems. Corroded cable. Clean and lubricate the cable.
Rudder worn. See authorized MasterCraft dealer’s
service department.
Excessive vibration. Bent strut. Replace the strut.
Fouled propeller. Remove objects from the propeller shaft and rudder.
Damaged propeller. Replace the propeller.
Misaligned propeller shaft coupling. Seek proper alignment.
Bent propeller shaft. See authorized MasterCraft dealer’s
service department.
Electrical problems. Open circuit breaker or blown fuse. Re-set the circuit breaker or replace the fuse.
Loose wiring connections or corrosion. Clean and tighten wiring connections.
Defective sending unit. Replace the sending unit.
Shorted wiring harness. Have the wiring harness repaired.
Defective switch or gauge. See authorized MasterCraft dealer’s
service department.
No speedometer reading. Defective speedometer. Have the speedometer checked or replaced.
Defective speedometer paddle wheel. Have paddle wheel checked or replaced.
Incorrection speedometer reading. Improper calibration. Follow calibration instructions in
Instruments and Gauges section
of this Manual.
Gauges do not work or the Breaker has tripped. Re-set the breaker.
accessory does not work. Fuse has blown. Replace the fuse.
Low battery. Check the battery voltage for a loose ground.
Insufcient battery supply. Replace battery with one that has at least 750CCAs.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft prostar 197, X-7 and is the answer not in the manual?

MasterCraft prostar 197, X-7 Specifications

General IconGeneral
BrandMasterCraft
Modelprostar 197, X-7
CategoryBoat
LanguageEnglish

Related product manuals