This vacuum is shipped assembled. It is
equipped with a air-thru motor, designed
for dry pickup only.
The paper filter bags and a impact filter
shipped with the vacuum MUST be
installed before operating the vacuum.
FILTER
INSTALLATION
& REMOVAL
(A) Press the holdown clamp upward and
remove the motor head and set aside.
(B) Remove the cloth filter assembly (F),
set aside.
(C) Expand the bag pleats to form full
shape of bag. Position hole in collar to end
of inlet tube and pull forward until collar is
completely on the tube and as close to the
tank wall as possible.
Always exercise caution when handling the motor head.
Dropping the motor head may cause permanent damage to internal components.
CAUTION:
PAGE 4
1) Place the impact filter around the
perimeter of the tank.
2) Replace cloth filter
assembly and secure clamps.
Paper Filter Bag Removal:
1) Pull the paper filter bag out of tank using care
not to puncture bag with inlet tube. Install a new
bag and dispose of the full bag.
2) Replace impact filter and dry filter assembly.
3) Replace motor head on tank and close clamps.
Paper Filter Bag Installation:
Impact Filter Installation:
To Next Page
Loading...
Need help?
General