F
ILTER
M
AINTENANCE
Cloth
Filter
Assembly
In order to maintain maximum efficiency of
this vacuum it is important to clean the
cloth filter each time the tank is emptied.
To clean the cloth filter, shake off loose par-
ticles and vacuum the cloth or, for a more
thorough cleaning wash and allow to dry
Note: Water temperature should be not
more than 72°F when washing the cloth
filter.
Motor
Filter
Clean the filter (E) after changing the paper
filter bag. After 10 paper bag changes
replace the filter. The blue side of the filter
must be visible.
ATTACHMENT
INSTALLATION
Hose &
Swivel
Connector
The vacuum hose and swivel connector
are preassembled at the factor. To
attach the swivel connector to the
intake fitting on the vacuum tank.
1) Line up the slots in the swivel con-
nector with retaining rivets on inlet.
2) Insert swivel connector and twist
clockwise until the rivets reset against
slot ends.
Wand,
Tools &
Hose
1) Firmly connect wand pieces and tool
required for your cleaning operation.
2) Insert vacuum hose into wand elbow.
3) Plug in power cored and turn on the
vacuum switch.
Wand
Vacuum
Control
1) The vacuum control located on the
upper part of the wand adjusts the vac-
uum power for cleaning different types
of surfaces.
PAGE 5
This vacuum is equipped with a thermal cut-off. If the thermal cut-off shuts OFF the
vacuum, change the filter bag and make sure there is nothing lodged in the hose or
wand. The thermal cut-off may take up to 20 minutes to reset itself.
CAUTION:
To Next Page
Loading...
Need help?
General