2023 OWNER’S MANUAL
/
114
Select FUEL MANAGEMENT
from the menu. This will
re-open the fuel level
entry page.
Using the keypad and the +/- button, adjust to the correct amount
of fuel. Use a positive value if more fuel needs to be entered, or a
negative value if too much fuel was entered.
If the fuel management system senses that fuel is getting low, it
will display a low fuel warning on the screen. The boat will be able
to run unballasted for approximately 20 minutes before running
out of fuel. When you see the low fuel warning, immediately empty
all ballast tanks and proceed to a fueling station before engaging
in any further activity. Continuing to operate the boat with low fuel
levels could leave users stranded oshore.
If an operator has inaccurately or mistakenly entered the fuel level,
there is a sensor in the fuel tank which will override the incorrect
entry when low fuel is detected. To avoid false readings, the sensor
will only override the fuel management system if and when it
detects a low fuel level for more than 30 seconds with the engine
operating at less than 900 RPM.
To activate or deactivate the fuel management software:
• Navigate to the Main Menu tab.
• Tap SYSTEM SETTINGS.
• On the System Settings Page, select either ENABLE or DISABLE
under Fuel Management.
Disabling the fuel management software will allow the fuel gauge
to read fuel levels directly from the sensor on the fuel tank. You
must reset this sensor when disabling fuel management. To do
so, cycle the battery switch ON then OFF. With the key switch OFF,
fill the fuel tank to 100% full at a fueling station. Turn the battery
switch ON, then turn the key switch back ON.
navigate to the Main Menu tab. Select FUEL MANAGEMENT from
the menu. This will re-open the fuel level entry page.
To Next Page
Loading...
Need help?
General
