115
/
2023 OWNER’S MANUAL
GUIDELINES FOR REFUELING
WITH INACTIVE FUEL
MANAGEMENT
• Always fill up with the key switch off.
• Filling boat completely full from the same location with a
consistent ethanol content level, such as a marina, storage tank
or gas station, will aid to maintain a more accurate fuel
gauge reading.
• If refueling with a different grade and/or ethanol content
than the existing fuel content in the boat, fill the tank completely
full with the key in an “Off” position in order to initiate the
recalibration of the fuel sensor.
Note* When refueling from various sources with different levels of
ethanol in the fuel, always wait until the fuel gauge indicates less
than 1/2 fuel tank level before refueling. The key must be in the
“OFF” position and the fuel tank must be completely refilled.
These critical guidelines signal the software to activate
the modem to prepare for recalibration. After the tank is
completely refilled and the key switch turned “ON”, the fuel
will alert a sensor at the top of the sender, triggering the
recalibration procedure and adjusting for the ethanol content
in the tank.
When the low fuel warning appears, immediately empty all ballast
tanks and proceed to the nearest fueling station or dock.
DIAGNOSTICS
You may access all PDM, EPDM, tab, and engine diagnostic
information under DIAGNOSTICS in the Main Menu. Tapping any of
the listed options will load system-specific diagnostics:
To Next Page
Loading...
Need help?
General
