• Repeat the previous step on the second side. Note: These last
two steps are important to ensure that the tower does not come
loose during operation.
Lowering and Raising the ZFT0 Tower
The ZFT0 tower is an upright, fixed tower. The towers can be lowered
by removing two bolts, which are the front bolts on either side of the
tower.
• Depending upon the total aggregate weight of the tower and any
installed accessories, it is advisable to have a second person
assist in steadying the tower during the raising and lowering
process on the ZFT0 tower.
Lowering and Raising the ZFT4 Tower
The ZFT4 tower can be manually raised or lowered (for storage or
ease of towing over the road.) The locking mechanisms located
on each side of the tower are pulled out to allow the tower to
raise or lower.
Always reinstall the locking mechanism on both sides of the ZFT4
tower immediately after raising or lowering the tower. Failure to
do so could result in damage to the tower or collapse of the tower,
which could result in serious injury or death.
Depending upon the total aggregate weight of the tower and any
installed accessories, it is advisable to have a second person assist
in steadying the tower during the raising and lowering process on
the ZFT4 tower.
To Next Page
Loading...
Need help?
General
