2021 OWNERS MANUAL / 104
Use the keypad and the +/- button to adjust to the correct amount
of fuel. Use a positive value if more fuel needs to be entered, or use
a negative value if too much fuel was entered.
When the fuel management system senses that fuel is getting low
it will display a low fuel warning on the screen. When this warning is
displayed, the boat will be able to run unballasted for approximately
20 minutes before running out of fuel. Empty all ballast tanks and
immediately proceed to a fueling station before any further activity.
Continuing to operate the boat with low fuel levels could leave users
stranded oshore.
If an operator has inaccurately or mistakenly entered the fuel level,
there is a sensor in the fuel tank that will override the entered fuel
level when it senses low fuel. To avoid false readings, the sensor will
only override the fuel management system when it detects a low
fuel level for more than 30 seconds with the engine operating at
less than 900 RPM.
To ENABLE or DISABLE the fuel management software:
• Navigate to the Main Menu tab.
• Tap SYSTEM SETTINGS.
• On the system settings page, select either ENABLE or DISABLE
under Fuel Management.
Disabling the fuel management software will allow the fuel gauge to
read fuel levels directly from the sensor on the fuel tank. You must
reset the sensor when disabling fuel management. To do this, cycle
the battery switch ON then OFF. With the key switch OFF, fill the fuel
tank to 100 percent full at a fueling station. Turn the battery switch
ON, then turn the key switch back ON.
2021MCOwnerManualFINAL.indd 104 8/26/20 1:51 PM
To Next Page
Loading...
Need help?
General
