2023 OWNER’S MANUAL
/
288
4. Cover the rest of the boat to the transom. Pull the canvas down
below the rubrail on XT and NXT models and use the ratcheting
straps to secure the cover onto the boat. Ratchet the straps
until they cannot be tightened further. The cover is designed to
ratchet very tight.
For X Series models pull the cover down below the style line as
5. Unzip the rope cleat cover and pull aft on the drawstring until
the cover is lifted up towards the tower, such that there are
no portions of the canvas that sag into the boat. Secure the
drawstring to the rope cleat on the cover. Zip the rope cleat cover
to prevent water intrusion. NOTE: Covers are custom designed
for each boat model. Your cover has bow and stern sections
that match the layout of your boat. It is critical that the cover is
oriented properly when installing.
Failure to use anti-pooling poles to support the mooring cover
during storage, or while trailering the boat could cause damage to
the mooring cover, the boat, or the trailer.
Correct Placement - X Series Incorrect Placement - X Series
Correct Placement - XT Series
Correct Placement - NXT Series
pictured. Use the ratcheting straps to secure the cover in place.
To Next Page
Loading...
Need help?
General
