2023 OWNER’S MANUAL
/
296
Location
The engine flush connection is mounted on the pylon brace
crossbar inside the engine hatch.
Operation
The engine flush connection allows for quick and easy connection
to a shore-side garden hose or similar hose to quickly and easily
flush the engine. See the ILMOR Engine Owner’s Manual for
additional details regarding this important function. The flush
connection is located on the transom.
Troubleshooting
If a hose will not connect to the flush connection, locate a dierent
hose. Garden hoses work fine as long as the hose end is not bent or
misshapen.
If water will not enter through the flush connection, disconnect the
hose and check that there is no obstruction in the connection area.
If there is no obvious reason for the system malfunction, take the
boat to an authorized MasterCraft dealer for assistance.
Therefore, to avoid conflict with the U.S.C.G., owners and operators
should never drive their boat while the side shades are deployed
upright. This angle should only be used when the boat is in the
process of docking. In any other operational circumstances, upright
deployment is unacceptable and should be avoided.
An unobstructed masthead light can protect those onboard from
potential collision incidents. Therefore, it is highly important that
you observe the above guidelines regarding side shades.
Except when docking the boat, the side shades should never be
deployed upright under any operational circumstances
ENGINE FLUSH
Models
The engine flush is standard on all models.
Purpose
Boats that will be operated in salt water (or brackish fresh water)
need to be rinsed after every use, including internal engine parts
where water has been drawn.