365
/
2023 OWNER’S MANUAL
SEADEK PADS
Models
All X, XT, NXT, and Star Series models.
Purpose
SeaDek provides an EVA foam-based alternative to carpet.
SeaDek is installed using a stick-on adhesive and is not intended
to be removable.
Location
SeaDek pads adhere directly to the flooring, gunnels and other
locations around the boat.
Care
SeaDek Marine Products recommends using Dek MagicTM cleaner,
which has been specifically developed for easy cleaning of PE/EVA
nonskid materials and is eective on a variety of stains. Dek Magic
is available for purchase on seadek.com. For best results, wet with
water then spray Dek Magic liberally over the entire area. With a
medium bristled brush, lightly work the product in. Let the cleaner
sit for 3-5 minutes then use water to dampen the area and lightly
scrub again. Rinse the cleaner o thoroughly and dry with a clean
towel. For stubborn stain, repeat these steps as needed.
If Dek Magic is not available, see the below steps for other
cleaning options.
Dirt and Footprints
Use an all-purpose cleaner, degreaser, or dish soap along with
warm water and a medium bristled brush. Thoroughly work the
soapy mixture into the SeaDek until stain comes up. Rinse with
clean water and repeat if necessary.
Suntan Lotion, Grease, and Oils
Use an all-purpose cleaner or degreaser alone with a medium
bristled brush. Put small amount of the cleaner on the oil stain and
use a medium bristled brush and warm water to scrub until the oil
is out. Rinse with clean water and repeat if needed.
Rust Stains
Wet the aected area and apply a dry, powdered Oxalic acid (such
as Barkeeper’s Friend) to the rust stain. Use a medium bristled
To Next Page
Loading...
Need help?
General
