2023 OWNER’S MANUAL
/
366
brush to work the powder into the stain and allow to soak for 3-5
minutes. Rinse with water and repeat if necessary. When applying
oxalic acid, use care to avoid getting acid on the edges of the pad,
as it could damage the lamination or PSA.
Please follow your state and/or country regulations for proper
chemical handling.
Wear vinyl or nitrile gloves and eye protection when necessary.
USE WITH CARE
• Although highly effective, using a pressure washer to clean
SeaDek pads can cause damage if not done properly.
DO NOT exceed 1200 PSI. Spray from the middle to the outside
of the pads. Do not point the pressurized spray under the edge
of the pad.
• Acetone (if it must be used, avoid the edges of the pad to
protect the adhesive)
• Oxalic Acid (if it must be used, avoid the edges of the pad to
protect the adhesive)
• Bleach (if used, dilute 1 cup with 1 gallon of water)
DO NOT USE
• Citrus Cleaners
• Mineral Spirits
For best cleaning results, tend to all stains, spills, and leaks as
soon as possible.
To Next Page
Loading...
Need help?
General
